Sanyo PJ-Net Organizer Plus POA-PN40 - Manual (Page 44)

44
Chapter 4 Controlling the Projector
Item Description
Contrast .............Adjusts picture contrast (0~ 63)
Brightness .........Adjusts picture brightness (0~ 63)
Color ..................Adjusts picture color saturation (0~ 63)
Tint .....................Adjusts picture hue (0~ 63)
Image adjustment
This function is to adjust the projected picture image and save the image mode. To
store the adjusted value, click Store button, and to load the adjusted value, click Load
button.
Item Description
Color Temp. ........... Sets a color temperature mode. (X Low, Low, Mid, High,
Adj.)
White Balance
Red, Green,
Blue ................ Adjusts each white balance respectively. (0~ 63)
Sharpness .........Adjusts picture sharpness. (0~ 31)
* When changing the value of the white balance, the color temp.
indicates "Adj."
Item Description
Gamma ................ Adjusts brightness of darker part of the picture. (0~ 15)
Noise reduction ... Switches noise reduction mode (OFF, L1, L2)
Progressive scan ... Switches progressive mode (ON, OFF, Film)
Reset .................Resets the Image adjustment to previous levels.
Store .................. Stores the Image adjust-
ment values. Select an
item [Image1 - Image10]
from the pull-down menu
and click Store button.
Load .................. Loads the Image mode.
Select an image mode
from the pull-down menu
and click Load button.
There may not be available
mode depending on the
input mode as shown in
the table left.
Input source
Image mode Video Computer
Standard(AV)
✔ *
Cinema ✔ *
Standard(PC) * ✔
Real * ✔
Image1 - 10 ✔ ✔
✐ The mark " ✔ " means that the available image mode in the
selected input source. The error message appears when
selecting the disabled image mode indicated with "*".