SUPER MICRO Computer SUPERSERVER 6012L-6 - Manual (Page 62)

6-2
S UPER S ERVER 6012L-6 Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the motherboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF1 on the motherboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3:
System Interface" an explanation of the control panel buttons and the
Onboard Indicators section in Chapter 5 for details on the motherboard
LEDs. Details on JF1 can be found in "Chapter 5: Advanced Motherboard
Installation."
Control Panel
Main Power
Slim-Line CD-ROM Drive Floppy Drive
SCSI Drives NMI
Ethernet Ports
USB Ports
Mouse Port Keyboard Port
COM1 Port
Standard Size PCI Slot
VGA Port Ext. SCSI Port
RJ45 Serial Port
USB Ports