Sabo 108-17 HS - Manual (Page 17)

Operating - 13
OPERATING
MX4896a
a. Turn right blade (E) so blade tip points straight
forward.
b. Measure from blade tip to the surface. Take
measurement for both blades.
The front blade tip must be 3–6 mm (1/8 -1/4 in.) lower
than rear blade tip.
c. Adjust mower level, if necessary.
Adjusting Mower Level
NOTE: Mower wheels should not contact the ground
when leveling the deck.
1. Make sure machine is on a flat level surface.
2. Raise mower deck to highest position.
MX7674x; MX7674b
3. Place a straight 2x4 piece of wood (A) or a 38 mm (1.5
in.) thick block under the edge (B) of each side of mower
deck.
• Shims can be added, on both sides, between block of
wood and mower deck edge to obtain a specific deck
height, if desired.
4. Put mower lift handle in the lowest position, bringing
deck down onto blocks.
5. Check that blocks are positioned under each edge.
Make sure blocks do not interfere with gage wheels.
6. Check that there is no tension on the front draft arm. If
necessary, loosen adjusting nut (C) on front draft arm so
front of deck rests on wood blocks.
c
CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
E
C
B
A