Sabo 108-17 HS - Manual (Page 39)

Service Mower - 35
SERVICE MOWER
Service Mower
Removing Mower
1. Park machine safely. (See Parking Safely in SAFETY
section.)
2. Put wood blocks under each side of mower deck.
3. Put lift lever in lowest position, bringing deck down onto
blocks.
MX10517; MX7681
4. Disconnect PTO drive cable (A).
a. Remove spring locking pin (B), pull and hold PTO
drive cable out, lift up and remove from bracket (C).
b. Remove cable spring (D) from idler sheave bracket
(E).
MX10516
5. Remove spring locking pins and washers (F) and
disconnect rear draft arms (G), two on each side.
MX10521
6. Remove spring locking pin and washer (H) and front
draft rod (I) from mower deck bracket (J).
7. Remove mower drive belt from drive sheave (K).
8. Remove wood blocks from both sides and slide mower
out from under the machine.
9. When operating the machine without the mower deck:
• Remove rear draft arms and front draft rod from
tractor and attach them to the mower deck.
c
CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
A
B
C
E
D
F
F
G
I
J
H
K