Sabo 108-17 HS - Manual (Page 41)

Service Mower - 37
SERVICE MOWER
MX7681; MX10517
a. Route cable under mower belt and brake rod and
attach cable spring (H) to idler sheave bracket (I).
b. Pull out on cable (J), align black end of cable with slot
in bracket (K) and release cable into slot. Secure with
spring locking pin (L).
11.Level mower.
Replacing Mower Drive Belt (107 cm (42 in.)
Deck)
1. Park machine safely. (See Parking Safely in the
SAFETY section.)
2. Remove mower deck.
3. Remove drive belt.
MX10511
a. Remove three capscrews and belt shield (A).
b. Loosen sheaves (B) and belt guides (C).
c. Remove mower belt.
4. Inspect belt for wear or damage; replace as necessary.
5. Clean top surface of mower deck and sheaves.
MX10512
6. Install belt on mower deck as shown. Make sure belt is
in the groove of each sheave and inside belt guides (D).
7. Tighten sheaves to 47 N•m (35 lb-ft).
8. Install belt shield(s).
9. Install mower deck.
10.Adjust mower belt tension and spindle brakes, if
c
CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
H
I
J
K
L
A
B
C
D