Sabo 108-17 HS - Manual (Page 18)

Operating - 14
OPERATING
MX7674x
7. Loosen leveling nut (D), one on each side, and make
sure bolts and leveling brackets slide freely in slots.
8. Raise lift handle to highest position and then lower back
down to 25 mm (1 in.) cutting height to position the deck
and brackets.
9. Apply slight pressure on leveling brackets (E), one on
each side, by pulling down to remove slack in linkage.
Tighten nuts (D), one on each side, to 55 N•m (40 ft-lbs).
10.Turn adjusting nut (C) on front draft arm clockwise until
deck begins to raise off wood blocks.
11.Set preferred cutting height.
12.Check front-to-rear mower level again and adjust if
necessary.
MX10529
• Turn front adjusting nut (C) clockwise to raise front of
mower deck or counterclockwise to lower front of mower
deck.
Testing Safety Systems
Use the following checkout procedure to check for normal
operation of machine.
If there is a malfunction during one of these procedures, Do
not operate machine. See your Sabo dealer for service.
Perform these tests in a clear open area. Keep bystanders
away.
Testing Park Brake Switch
1. Park machine safely. (See Parking Safely in the
SAFETY Section.)
2. Sit on seat.
D
E
C
C
c
CAUTION: Avoid injury! Engine exhaust fumes
contain carbon monoxide and can cause
serious illness or death.
Move the vehicle to an outside area before
running the engine.
Do not run an engine in an enclosed area
without adequate ventilation.
• Connect a pipe extension to the engine
exhaust pipe to direct the exhaust fumes out of
the area.
• Allow fresh outside air into the work area to
clear the exhaust fumes out.