Sabo 108-17 HS - Manual (Page 40)

Service Mower - 36
SERVICE MOWER
MX10514
• Push PTO drive cable into clip (L) and hook end of
cable spring with hardware (M) into peg on left side of
machine frame.
Installing Mower
1. Park machine safely. (See Parking Safely in SAFETY
section.)
2. Put lift lever in the transport position.
3. Slide mower under machine.
4. Put wood blocks under each side of mower deck.
5. Put lift lever in lowest position.
MX10516
6. Fasten rear draft arms (A), two on each side, with
washers and spring locking pins (B).
MX10529
7. Install front draft rod (C) into mower deck bracket (D)
and secure with washer and spring locking pin (E) on the
left side of bracket as shown.
MX10521
8. Put mower drive belt on engine drive sheave (F). Make
sure belt is routed through both belt guides (G)
9. Remove wood blocks from both sides of mower deck.
10. Attach PTO drive cable.
c
CAUTION: Avoid injury! Rotating blades are
dangerous. Before adjusting or servicing
mower:
• Disconnect spark plug wire(s) to prevent
engine from starting accidently.
• Always wear gloves when handling mower
blades or working near blades.
L
M
B
B
A
IMPORTANT: Avoid damage! To prevent clutch
damage, make sure front draft rod is installed
correctly. Secure rod with washer and spring
locking pin on the left side of mower deck bracket.
C
D
E
G
F