Rts line state, Beep on <bel, Rts line state -18 beep on <bel> -18 – Symbol Technologies DS 3408 User Manual
Page 100
Advertising
DS 3408 Product Reference Guide
7-18
Host Serial Response Time-out (continued)
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High RTS line state.
Beep on <BEL>
When this parameter is enabled, the digital scanner issues a beep when a <BEL> character is detected on the RS-232 serial line.
<BEL> is issued to gain a user's attention to an illegal entry or other important event.
Maximum: 9.9 Sec
*
Host: Low RTS
Host: High RTS
Beep On <BEL> Character
(Enable)
*
Do Not Beep On <BEL> Character
(Disable)
Advertising