Upc/ean/jan supplemental redundancy, Upc/ean/jan supplemental redundancy -14, Ropriate – Symbol Technologies DS 3408 User Manual
Page 172: Upc/ean/jan, Supplemental redundancy
DS 3408 Product Reference Guide
13-14
Decode UPC/EAN/JAN Supplementals (continued)
UPC/EAN/JAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a symbol without
supplementals is decoded before transmission. The range is from two to thirty times. Five or above is recommended when decoding
a mix of UPC/EAN/JAN symbols with and without supplementals, and the autodiscriminate option is selected. The default is set at 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Single digit numbers must have a leading zero. To correct an error or change a selection, scan Cancel on page
.
Enable 378/379 Supplemental Mode
(04h)
Enable 978 Supplemental Mode
(05h)
Enable Smart Supplemental Mode
(03h)
UPC/EAN/JAN Supplemental Redundancy