Symbol Technologies DS 3408 - Manual (Page 339)

Standard Default Parameters A-3
Table A-1. Standard Default Parameters Table
Parameter
Parameter
Number Default
Page
Number
User Preferences
Set Default Parameter All Defaults 4-5
Parameter Scanning ECh Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-7
Power Mode 80h Continuous On 4-7
Time Delay to Low Power Mode 92h 5 Minutes 4-8
Trigger Mode 8Ah Level 4-9
Decode Session Timeout 88h 9.9 Sec 4-10
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 4-10
Beep After Good Decode 38h Enable 4-11
Scanstand Session Timeout F0h 90h 2 Seconds 4-11
Decoding Preferences
Focus Mode F0h A6h Far Focus 5-5
Decoding Illumination F0h 2Ah Enable 5-6
Decode Aiming Pattern F0h 32h Enable 5-6
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC Compatibles
1
6-5
Country Types (Country Codes) North American 6-6
Ignore Unknown Characters Transmit 6-8
Keystroke Delay No Delay 6-8
Intra-Keystroke Delay Disable 6-9
Alternate Numeric Keypad Emulation Disable 6-9
Caps Lock On Disable 6-10
Caps Lock Override Disable 6-10
1
User selection is required to configure this interface and this is the most common selection.