Symbol Technologies DS 3408 - Manual (Page 136)

DS 3408 Product Reference Guide 10-4
1. Attach the modular connector of the Wand Emulation interface cable to cable interface port on the digital scanner (see
Installing the Interface Cable on page 1-4 ).
2. Connect the other end of the Wand Emulation interface cable to the wand port on the mobile computer or controller.
3. Select the Wand Emulation host type by scanning the appropriate bar code from Wand Emulation Host Types on page 10-5 .
4. To modify any other parameter options, scan the appropriate bar codes in this chapter.
Connect the digital scanner to 5 volt decoders only. Connecting the digital scanner to a 12 volt
decoder can damage the digital scanner and invalidate the warranty.
Wand Emulation Parameter Defaults
Table 10-1 lists the defaults for Wand Emulation host types. To change any option, scan the appropriate bar code(s) provided in Wand
Emulation Host Parameters on page 10-5 .
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 10-1. Wand Emulation Default Table
Parameter Default Page Number
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface
Controller 10-5
Leading Margin 80 msec 10-6
Polarity Bar High/Margin Low 10-7
Ignore Unknown Characters Ignore 10-7
Convert All Bar Codes to Code 39 Disable 10-8
Convert Code 39 to Full ASCII Disable 10-9
WARNING
Note