Sangean K-200 - Manual (Page 16)

15
Presetting stations in AM/FM modes
There are 5 preset stations each for AM and FM radio. They are used in
the same way for each waveband.
1. Press the Standby button to switch on your radio.
2. Press the Band button to select the desired waveband. Tune to the
required radio station as previously described.
3. Press and hold the required main Preset button (1 to 5) until the
display shows “P1” after the frequency. The station will be stored
using the preset number. Repeat this procedure for the remaining
presets as you wish.
4. Preset stations which have already been stored may be overwritten
by following the above procedure if required.
Recalling a preset in AM/FM modes
1. Press the Standby button to switch on your radio.
2. Select the required waveband by pressing the Band button.
3. Momentarily press the required main Preset button to cause your
radio to tune to one of the stations stored in the 5 main presets.
3