Sangean K-200 - Manual (Page 21)

20
4. Rotate the Tuning control to choose the required alarm type, and then
press and release the Tuning control to confirm the setting. The alarm
can be set to buzzer, AM radio, FM radio or voice message
(MSG1, MSG2 or MSG1+2). When radio mode is selected, the radio
frequency and the preset number on the display will begin to flash.
Rotate the Tuning control to adjust the required radio frequency or
the required preset number for the radio alarm, then press and
release the Tuning control to confirm the setting.
5. The alarm has now been set. The radio will beep once, and then will
revert to normal display.
6. Rotate the Volume control to set the required volume.
7. Adjust the switch inside the battery compartment to set the required
volume level for buzzer alarm. When the radio is set to wake by
FM radio or voice message, the alarm volume will be the volume
previously listened to.
Active alarms are shown using small alarm indicator on the display.
6
7
GB