Sun Microsystems GigaSwift Ethernet Adapter - Manual (Page 24)

2 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • August 2004
FIGURE 1-1 Sun GigaSwift Ethernet MMF Adapter
LED Displays on the MMF Adapter
Four LEDs are displayed on the front panel of Sun GigaSwift Ethernet MMF adapter.
They are labeled on the front panel as shown in
TABLE 1-1 .
Sun GigaSwift Ethernet UTP Adapter
The Sun GigaSwift Ethernet UTP adapter is a low-profile, single-port gigabit
Ethernet copper-based PCI bus card. It can be configured to operate in 10, 100, or
1000 Mbit/sec Ethernet networks. At 10 or 100 Mbit/sec the adapter can be set to
either half or full-duplex. At 1000 Mbit/sec, the adapter must operate at full-duplex.
TABLE 1-1 Front Panel Display LEDs for the MMF Adapter
Label Meaning if Lit Color Source
LINK Link is up. Green* MAC
FDX Link is in full-duplex mode. Green MAC
TX Link is transmitting. Green MAC
RX Link is receiving. Green MAC
*LED will not light until the latest version of the driver software is installed.
RX TX FDX LINK