Setting the autonegotiation mode – Sun Microsystems GigaSwift Ethernet Adapter User Manual
Page 71
Chapter 4
Configuring Driver Parameters
49
●
To list all the parameters supported by the
ce
driver, type
?
.
See
through
for parameter descriptions.
Setting the Autonegotiation Mode
By default, autonegotiation is set to
on
. This means that the adapter communicates
with its link partner to determine a compatible network speed, duplex mode, and
flow control capability.
# ndd /dev/ce
name to get/set ? ?
? (read only)
instance (read and write)
adv_autoneg_cap (read and write)
adv_1000fdx_cap (read and write)
adv_1000hdx_cap (read and write)
adv_100T4_cap (read and write)
adv_100fdx_cap (read and write)
adv_100hdx_cap (read and write)
adv_10fdx_cap (read and write)
adv_10hdx_cap (read and write)
adv_asmpause_cap (read and write)
adv_pause_cap (read and write)
master_cfg_enable (read and write)
master_cfg_value (read and write)
use_int_xcvr (read and write)
enable_ipg0 (read and write)
ipg0 (read and write)
ipg1 (read and write)
ipg2 (read and write)
rx_intr_pkts (read and write)
rx_intr_time (read and write)
red_dv4to6k (read and write)
red_dv6to8k (read and write)
red_dv8to10k (read and write)
red_dv10to12k (read and write)
tx_dma_weight (read and write)
rx_dma_weight (read and write)
infinite_burst (read and write)
disable_64bit (read and write)
accept_jumbo (read and write)
name to get/set ?
#