Spectra Watermakers BlueScale Vision 956YH60001 - Manual (Page 10)

4. Check the LEDs
• The Power LED will turn on briefly, then start blinking. It will blink during startup, which takes 15 to 20 seconds. After startup is
completed, the Power LED should remain ON.
• The Network LED should be ON.
For more information, refer to Physical Details - Network Camera in Chapter 1.
Setup using the Windows Wizard
Initial setup should be performed using the supplied Windows-based setup Wizard. This program can locate the Network Camera even
if its IP address is invalid for your network. You can then configure the Network Camera with appropriate TCP/IP settings for your
LAN.
Subsequent administration can be performed with your Web browser, as explained in Chapter 5 - Web-based Management.
Setup Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start automatically, run NetworkCamera.exe in the
NetworkCamera folder on the documentation CD that accompanied your library.
• You will see the Welcome screen shown below.
• Click the Setup Camera button to start the setup Wizard.
Figure 2: Welcome Screen
6