Spectra Watermakers BlueScale Vision 956YH60001 - Manual (Page 27)

Motion Detection Alerts
The Motion Detection feature can generate an Alert when motion is detected.
The Network Camera will compare consecutive frames to detect changes caused by the movement of large objects.
But the motion detector can also be triggered by:
• Sudden changes in the level of available light
• Movement of the camera itself.
Try to avoid these situations. The motion detection feature works best in locations where there is good steady illumination, and the
camera is mounted securely. It cannot be used outdoors due to the sensitivity of the CMOS sensor.
To Use Motion Detection Alerts
Using the Web-based interface on the Network Camera, select the Motion Detection screen, then configure this screen as described
below.
Figure 22: Motion Detection
1. Enable the Motion Detection feature.
2. Set the area or areas of the video image to be examined for movement. You can define up to 4 areas, and set the motion threshold
individually for each area.
3. If using a schedule, define the desired schedule in Event Trigger screen.
4. Save your changes.
23