Sony STR-DN1010 - Manual (Page 15)

15 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB03DES_STR-DN1010-CEL.fm masterpage: Right
STR-DN1010
4-174-068-12(1)
qh
w;
wa
qf
qj
ws
ql
qd
qk
wf
wg
wd
1
2
3
4
5
6
0
qa
qs
qg
7
8
9
Name and function
A ?/1 (on/standby)
Turns the receiver on or sets it to the standby
mode.
To turn off all components, press ?/1 and
AV ?/1 (B) at the same time (SYSTEM
STANDBY).
Saving the power in standby mode .
When “Ctrl for HDMI” is set to “OFF” (page
70) and “S-AIR Stby” is set to “OFF” (page 83).
B AV ?/1
a)
(on/standby)
Turns on or off the audio/video components that
the remote is programmed to operate.
To turn the TV on or off, press TV (W) and
then press AV ?/1.
If you press ?/1 (A) at the same time, it will
turn off the receiver and other components
(SYSTEM STANDBY).
Note
The function of the AV ?/1 switch changes
automatically each time you press the input
buttons (D).
C AMP
The button lights up and activates the receiver
operation (page 101).
D Input buttons (VIDEO 1 b) )
Selects the component you want to use. When
you press any of the input buttons, the receiver
turns on. The buttons are initial assigned to
control Sony components. You can program the
remote to control non-Sony components
following the steps in “Programming the
remote” on page 112.
Numeric buttons a) (number 5 b) )
Press SHIFT (V), then press numeric buttons
to
– preset/tune to preset stations.
– select track numbers. Press 0/10 to select track
number 10.
– select channel numbers.
Press TV (W), then press the numeric buttons
to select the TV channels.
-/-- a)
Press SHIFT (V), then press -/-- to select the
channel entry mode, either one or two digit.
To select the channel entry mode of the TV,
press TV (W) and then press -/--.
>10 a)
Press SHIFT (V), then press >10 to select track
numbers over 10. You can also select the
channel numbers of the DIGITAL CATV
terminal.
continued