Sony STR-DN1010 - Manual (Page 98)

98 GB
D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB05ENJ_STR-DN1010-CEL.fm masterpage: Left
STR-DN1010
4-174-068-12(1)
If the image is distorted when you connect to
video game, set “Comp.Dec.” to “ON”. This
setting is only applicable for component video
input signals.
x ON
x OFF
HDMI Settings menu
You can make the required settings for
components connected to the HDMI jack.
Lets you turn the Control for HDMI function
on or off. For details, see “Preparing for the
“BRAVIA” Sync” (page 70).
x ON
x OFF
Note
When you set “Ctrl for HDMI” to “ON”, “Audio
Out” may be changed automatically.
Lets you output the HDMI signals to the TV
even when the receiver is in standby mode.
x ON
When the receiver is in the standby mode, the
receiver continuously outputs HDMI signals
from the receiver’s HDMI TV OUT jack.
x AUTO
When the TV is turned on while the receiver is
in the standby mode, the receiver outputs
HDMI signals from the receiver’s HDMI TV
OUT jack. Sony recommends this setting if
you use a TV that is compatible with
“BRAVIA” Sync. This setting saves power in
the standby mode compared with the “ON”
setting.
x OFF
The receiver does not output HDMI signals
when in the standby mode.
Turn on the receiver to enjoy the connected
component’s source on the TV. This setting
saves power in the standby mode compared
with the “ON” setting.
Comp.Dec. (Component video
decoder)
Ctrl for HDMI (Control for HDMI)
Pass Through