Sanyo PLC WTC500L - Manual (Page 48)

48
Screen Size Adjustment (Video, Component Signals)
Press the MENU button to display the On-Screen
Menu. Use the Point 7 8 buttons to move the red
frame pointer to the Screen Menu icon.
1
Use the Point ed buttons to move the red frame
pointer to the desired function and then press the
SELECT button.
2
Provide the image at the 4:3 normal video aspect ratio.
Normal
Wide
Provide the image at the 16:9 wide screen ratio.
Move the red frame pointer
to the desired function and
press the SELECT button.
Screen Menu
Screen Menu icon
Screen Adjustment
Zoom
Expand the image to fit the width of screen. The images may be
displayed with their top and bottom areas cut off.
Expand the right and left side of images naturally without
changing the center areas.
Natural Wide
Full
Provide the full screen image.
Adjust the screen scale and position manually with this
function.
Press the SELECT button at Custom and the “Custom” is
displayed on the screen for a few seconds and then the
Aspect dialog box appears.
Scale H/V ........... Adjust the Horizontal/Vertical screen scale.
H&V ................... When set to “On,” the aspect ratio is
fixed. The “Scale V” appears dimmed and
becomes unavailable. Adjust “Scale H,”
then the screen scale is automatically
modified based on the aspect ratio.
Position H/V ....... Adjust the Horizontal/Vertical screen
position.
Common ............ Save the adjusted scale to all the inputs.
Press the SELECT button at Common to
display a confirmation box. To save the
scale, press the SELECT button at “Yes.”
When Custom is selected, the saved scale
is used.
Reset ................. Reset the all adjusted values. Press
the SELECT button at Reset to display
a confirmation box. To reset, press the
SELECT button at “Yes.”
Custom
✔ Notes:
• When no signal is detected, “Normal” is
set automatically and the Aspect dialog
box disappears.
• The adjustable range for Scale H/V and
Position H/V is limited depending on the
input signal.
• Wide cannot be selected when 720p,
1035i, or 1080i is selected in the AV
System Menu (p.36)
Press the SELECT button at
Common or Reset, to display a
confirmation box.