Lamp replacement, Caution, Maintenance and care – Sanyo PLC WTC500L User Manual

Page 67

Advertising
background image

67

When the total lighting time of a Projection Lamp

reaches the recommended total hours of use, the Lamp

replacement icon appears on the screen and LAMP 1 / 2

REPLACE indicator lights yellow. Replace the lamp with

a new one promptly. The timing when the LAMP 1 / 2

REPLACE indicator should light is depending on the lamp

mode.

Follow these steps to replace the lamp.

For continued safety, replace with a lamp of the same

type lamp. Do not drop the lamp or touch the glass

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes

before you open the Lamp cover. The inside of

the projector can become very hot.

CAUTION

Turn off the projector and unplug the AC power cord.

Let the projector cool for at least 45 minutes.

Lift the lamp out of the projector by using the handle.

1

3

Replace the lamp with a new one. Make sure that

the lamp is set properly. Put the lamp cover back and

secure it with the screw.

4

Remove the screw that secures the lamp cover with a

coin, and then open the lamp cover.

2

5

Lamp Replacement

CAUTION

Screw

Lamp replacement icon

Top Control

LAMP 1/2 REPLACE
indicators

Lamp cover

Maintenance and Care

Note:

• The Lamp replacement icon will not

appear when the Display function is set
to “Off” (p.56), or during “Freeze” (p.30).

Check the number of lamp to be replaced on the Lamp

Status Display or the LAMP 1/2 REPLACE indicators

and replace the lamp.

Handle

Lamp 1

Lamp 2

When replacing the lamp because it has stopped

illuminating, there is a possibility that the lamp maybe

broken. If replacing the lamp of a projector which has

been installed on the ceiling, you should always assume

that the lamp is broken, and you should stand to the side

of the lamp cover, not underneath it. Remove the lamp

cover gently. Small pieces of glass may fall out when

the lamp cover is opened. If pieces of glass get into your

eyes or mouth, seek medical advice immediately.

CAUTION

Note:

• After lamp replacement, make sure to check the Lamp

mode (p.53).

Advertising