Sanyo PLC WTC500L - Manual (Page 52)

52
Picture in Picture
This function is used to project two videos simultaneously
by placing a separate small sub screen within the main
screen.
Use the Point ed buttons to move the red frame
pointer to Picture in Picture and then press the
SELECT button to display a dialog box. Use the Point
7 8 buttons to adjust the setting mode.
✔ Note:
• The Picture in Picture function is not available
depending on the input signals and the selected
input terminals. Refer to ‘List of Picture in Picture‘
for details. (p.82)
• When the input signal(s) is/are incompatible, X
mark will be displayed on the Main/Sub picture.
• While the Main and Sub pictures are being
displayed, System, Image select, Image adj. and
Screen menus (except for ‘Keystone’, ‘Ceiling’
and ‘Rear’) are inoperative.
• Only the sound on the Main picture is heard,
the sound on the Sub picture cannot be heard
(In P in P, the big picture is main picture, and
the small one is Sub picture ; in P by P, the left
picture is Main picture, and the right one is Sub
picture.)
Setting
Mode ............Off
P in P: Provide the images of Sub picture
piling up to Main picture.
P by P: Provide the images of Main picture
and Sub picture side by side at the
same size .
Sub picture.... Size: Select the display size. (Middle/ Large/
Small)
Position: Select the Subpicture position.
(right bottom end/ right top end/
left top end/ left bottom end )
Select the Subpicture input at the Picture in Picture
or Picture by Picture mode :
Press the SELECT button, Sub picture is selected and the
Subpicture frame is indicated in red. Press the i ntended
INPUT button within 4 seconds and Input of Sub picture is
switched. Press the SELECT button again and Main display
is selected. Red frame of Sub picture will disappear. Press
the intended INPUT button and Input of Main picture is
switched when Main picture is selected.
Background
The selected background screen will be displayed when no
input signal is detected.
Blue ....... Project a blue background
User ....... Project an image selected in the Logo setting.
Black ...... Project a black background
✔ Note:
• When no captured image is set, the “User” options is not
available.
Button operation at the PIP mode on the remote
control and top control :
e : Replace the Main picture and Sub picture.
d : Change the Subpicture size.
7 : Change the Subpicture position
(counterclockwise)
8: Change the Subpicture position
(clockwise)
SELECT : Select the Sub picture or Main picture.
In Picture in Picture mode, press the SELECT button to
select the sub picture and Point ed7 8buttons operate
as follows.