Sony BRC-Z700 - Manual (Page 65)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Connections
65
Connecting a Video Monitor, VTR,
etc. Equipped with Composite
Video or S Video Input Connector Connecting a VTR Equipped with
SDI Input Connector
Attach the optional BRBK-HSD1 HD/SD-SDI Output
Card to the camera, set the HD/SD select switch on the
card to SD, and turn on the camera. You can output the
signal from the camera by converting it into an SDI
signal that conforms to SMPTE259M (for 59.94i signal
format) or ITU-R BT.656 (for 50i signal format) serial
digital interface standards.
You can change an image size (aspect ratio) of the
signals output from the SDI OUTPUT connector. For
details, see “SD-SDI Menu” on page 39.
Note
Signal processing in the output card causes all output
signals from the BRBK-HSD1 to be delayed by
approximately 93H (horizontal sync time) compared
with the YPbPr/RGB output signals from the camera. A
similar delay occurs when using an external sync signal.
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON
DATA MIX OFF ON
IN VISCA RS-232C OUT DC IN 12V
R
VIDEO S VIDEO
to AC outlet VIDEO
S video connecting
cable
Video monitor, VTR, etc.
to composite
video input
75-ohm coaxial
cable
to S video input
S VIDEO
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON
DATA MIX OFF ON
IN VISCA RS-232C OUT DC IN 12V
R
VIDEO S VIDEO
HD SD
to AC outlet
BRBK-HSD1
HD/SD-SDI Output Card
Connecting cable
with BNC connectors
to SDI input
DVCAM, etc. equipped with an
SDI input comnnector
SDI OUTPUT