Sony BRC-Z700 - Manual (Page 66)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Connections
66
Connecting a VTR Equipped with
HD-SDI Input Connectors
Attach the optional BRBK-HSD1 HD/SD-SDI Output
Card to the camera, set the HD/SD select switch on the
card to HD, and turn on the camera. You can output the
signal from the camera by converting it into a signal
compliant with HD-SDI standards (SMPTE292M serial
digital interface).
Notes
Signal processing in the output card causes all output
signals from the BRBK-HSD1 to be delayed by
approximately 4H (horizontal sync time) compared with
the YPbPr/RGB output signals from the camera. A
similar delay occurs when using an external sync signal.
Connecting the BRU-H700 HD
Optical Multiplex Unit
When you install an optional BRBK-H700 Optical
Multiplex Card in the camera, you can connect the
camera to the BRU-H700 Optical Multiplex Unit using
the CCFC-M100HG Optical Fiber Cable. This allows
you to control the camera from up to 1,000 m (3,281
feet) away.
Notes
• When the connection using the Optical Fiber Cable is
made, the VISCA RS-232C and VISCA RS-422
connectors on the camera cannot be used.
• When using the VISCA RS-232C connectors or
VISCA RS-422 connectors, check the VISCA
FUNCTION switch on the rear of the Optical
Multiplex Unit (page 25) and the DIP switch on the
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON
DATA MIX OFF ON
IN VISCA RS-232C OUT DC IN 12V
R
VIDEO S VIDEO
HD SD
BRBK-HSD1 HD/SD-SDI
Output Card
to AC outlet
SDI OUTPUT
Connecting cable
with BNC connectors
to HD-SDI input
HDCAM, etc. equipped with an
HD-SDI input comnnectors
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON
DATA MIX OFF ON
IN VISCA RS-232C OUT DC IN 12V
R
VIDEO S VIDEO
IN EXT SYNC OUT IN VISCA RS-232C OUT CAMERA
~ AC IN
VISCA RS-422
AUDIO
L
R
FUNCTION
1 6
RGB/COMPONENT
to AC outlet
BRBK-MF1 Optical
Multiplex Card
AC power cord
(supplied with
the BRU-H700)
CCFC-M100HG Optical
Fiber Cable
VISCA RS-232C IN
to AC
outlet
CAMERA
BRU-H700 HD
Optical Multiplex
Unit
RGB/
COMPONENT
connecting
cable with D-
sub 15-pin
connectors
(commercially
available)
HD monitor, etc.
RS-232C cable
(supplied with the
RM-BR300)*
VISCA RS-232C
RM-BR300 Remote Control Unit
to AC outlet
* The VISCA RS-422 connection is also available if you use the
VISCA RS-422 connectors.
Optical connector
to RGB/
component
input