Sim2 Multimedia DIGITAL D60 - Manual (Page 22)

22 Using the projector
Adjusting the projected image
Adjusting the projection angle
There are four adjuster feet on the bottom of the projector. These
can be used if necessary to change the projection angle. Screw
the feet in or out as appropriate to aim and level the projection
angle.
If the screen and the projector are not perpendicular to each other, the
projected image becomes vertical trapezoidal. To correct this problem, see
"Correcting picture
distortion" on page 22 for details.
Correcting picture distortion
Keystoning occurs when the projector is not perpendicular to the screen and is where the
projected picture displays visible as a trapezoid shape like either of the following:
•
Two parallel sides (left and right, or top and bottom) but is noticeably wider on either
side.
• No parallel sides.
To correct the picture's shape, you can perform the following steps.
1.
Adjust the projection angle. Move the projector to be in front of the center of the screen
with the base of the lens level with the top or bottom edge of the screen.
2. If the picture is stilled distorted, or the projector is unable to be positioned as described
above, you will need to manually correct the picture.
• Using the remote control
i. Press one of the Arrow keys on the remote control ( ,
) to display the Keystone page.
ii. See step iv below for further operation.
• Using the OSD menu
i. Press MENU and then press / until the Display menu is
highlighted.
ii. Press to highlight Keystone and press ENTER. The
Keystone page displays.
iii. Highlight 2D Keystone and press ENTER. The keystone
correction page displays.
iv. Press the key whose keystone icon is similar to the shape
of the projected picture. Continue pressing the same
key or press the other keys until you are satisfied with the
shape.
The values on the lower portion of the page change
while pressing. When the values reach their maximum or
minimum with repeated key presses, the picture's shape
will stop changing. You will not be able to change the
picture further in that direction.
Aspect Ratio
Keystone
Position
Overscan Adjustment
PIP
PC & Component YPbPr Tuning
Display
EXIT Back
0
S-Video
ENTER
Keystone
2D Keystone ENTER
EXIT Back
Keystone
EXIT Back
Anamorphic
1 0
System Color
Press .
Press .
Two parallel sides
No parallel sides
1. Press . 2. Press .