Sim2 Multimedia DIGITAL D60 - Manual (Page 5)

5 Overview
Overview
Shipping contents
The projector is shipped with the cables required for connection to video equipment. Some
of the items may not be available depending on your region of purchase. Please check with
your place of purchase.
Some of the accessories may vary from region to region.
Remote control batteries
1. To open the battery cover, turn the
remote control over to view its back,
push on the finger grip on the cover
and slide it down in the direction of
the arrow as illustrated. The cover will
slide off.
2. Remove any existing batteries (if
necessary) and install two new AAA batteries observing the battery polarities as
indicated in the base of the battery compartment. Positive (+) goes to positive and
negative(-) goes to negative.
3. Refit the cover by aligning it with the case and sliding it back up into position. Stop when
it clicks into place.
Notes on handling batteries
• Do not mix old batteries with new ones, or mix different types of batteries.
• Avoid leaving the remote control and batteries in an excessive heat or humid
environment like the kitchen, bathroom, sauna, sunroom, or in a closed car.
• Dispose of used batteries according to the battery manufacturer’s instructions and local
environment regulations for your region.
• If the remote control will not be used for an extended period of time, remove the
batteries to avoid damage to the control from possible battery leakage.
Remote control operation
• Make sure that there is nothing positioned
between the remote control and the infrared
(IR) sensor on the projector that might
obstruct the IR beam from the remote control
reaching the projector.
• The effective range of the remote control is
up to 8 meters, and at an angle within 60
degrees of the IR beam. Always aim straight
at the projector, however most screens will also reflect the IR beam to the projector.
Projector Power cables
Component
Video cable
Remote
control
Batteries
User manual
CD
Quick
start
guide
(EU) (UK) (US)
up to 8m