Sim2 Multimedia DIGITAL D60 - Manual (Page 23)

23 Using the projector
Using the preset and user modes
Selecting a picture mode
The projector is preset with several pre-defined picture modes so that you can choose one to
suit your operating environment and input source picture type.
To select a picture mode that suits your need:
• Using the remote control
1. Press PICTURE MODE repeatedly or USER 1, USER 2, USER 3 on
the remote control until your desired mode is selected.
• Using the OSD menu
1. Press MENU and then press / until the Image menu is
highlighted.
2. Press to highlight Picture Mode.
3. Press / until your desired mode is selected.
These modes consist of preset values suitable for various
projection situations as described below:
•
Cinema Mode: with well-balanced color saturation and
contrast with a low brightness level. This is most suitable for
enjoying movies in a totally dark environment (as you would
find in a commercial cinema).
• Dynamic Mode: Maximizes the brightness of the projected
image. This mode is suitable for environments where extra-
high brightness is required, such as using the projector in well
lit rooms.
• Standard: Is slightly brighter than Cinema Mode mode, and
suitable for use in rooms where there is a small amount of
ambient light.
• User 1/User 2/User 3: Recalls the customized settings. See "Setting the User 1/User 2/User 3
mode" on page 24 for details.
Fine-tuning the selected picture mode
The pre-defined picture mode settings can be altered via the available items shown in the
Image and Color menus.
To fine-tune the picture mode:
1. Press MENU and then press / until the Image or Color menu is highlighted.
2. Press to highlight the item you want to adjust (from among Brightness, Contrast, Color,
Tint, Sharpness, Black Level, Clarity Control, Color Temperature, Gamma Selection,
Brilliant Color, Color Management, IRIS) and press / to set your desired value. Your
selection is automatically stored in the projector and associated with that input source.
See
"Fine-tuning the picture quality" on page 25 and "Advanced picture quality controls"
on page 26 for details.
Each time you change the picture mode, the projector also changes the setting to the one
which was last set for that particular picture mode on that particular input. If you change the
input source, the most recently used picture mode and settings for that input and resolution
will be restored.
Picture Mode
Load Settings From
Brightness
Contrast
Tint
Sharpness
Reset Picture Settings
Rename User Mode
Image
+50
0
S-Video
Cinema Mode
EXIT Back
Color
+50
+50
+ 2
Information Color