Sim2 Multimedia DIGITAL D60 - Manual (Page 41)

41 Additional information
Additional information
Care of the projector
Your projector needs little maintenance. The only thing you have to do on a regular basis is
keep the lens clean and clean or replace the air filter. Never remove any parts of the
projector except the lamp or the air filter. Contact your dealer or local service centre if the
projector fails to operate as expected.
Cleaning the lens
Clean the lens whenever you notice dirt or dust on the surface. Before you attempt to clean
the lens, turn the projector off, unplug the power cable, and leave it several minutes to cool
completely.
1.
Use a canister of compressed air to remove dust. (Available from building hardware or
photographic suppliers.)
2. If there is stubborn dirt or smudge marks, use a proper photographic lens brush or
moisten a clean soft lens cloth with lens cleaner to gently wipe the lens surface.
Never touch the lens with your finger or rub the lens with abrasive materials. Even paper towels can
damage the lens coating. Only ever use a proper photographic lens brush, cloth, and cleaning solution.
Do not attempt to clean the lens while the projector is switched on or is still hot from previous use.
Cleaning the projector case
Before you attempt to clean the case, turn the projector off, unplug the power cable, and
leave it several minutes to cool completely.
1.
To remove dirt or dust, wipe the case with a soft, dry, lint-free cloth.
2. To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral
detergent. Then wipe the case.
Never use wax, alcohol, benzene, thinner or other chemical detergents. These can damage the case.
Storing the projector
If you need to store the projector for an extended time, please:
1.
Make sure the temperature and humidity of the storage area are within the
recommended range for the projector. Please refer to the Spec. page in this manual or
consult your dealer about the range.
2. Retract the adjuster feet.
3. Remove the batteries from the remote control.
4. Pack the projector in its original packing or equivalent.
Transporting the projector
It is recommended that you ship the projector with its original packing or equivalent. When
you carry the projector yourself, please use a soft carry case.
Cleaning and replacing the dust filter
The message to the right displays periodically every
500 hours use. You can also use the Setup > Dust Filter
> Dust Filter Hours menu or the Information > Dust
Filter Hours menu to check how long the filter has
been used. If the filter is not cleaned, it can become
clogged with dust and prevent proper ventilation.
This can cause overheating and a malfunction of the
projector. Should the projector filter become seriously
clogged with dust, it can cause over-heating inside
of the projector.
WARNING
Please check if the filter is clean.
Clean the filter or replace
with a new one.
OK
FILTER CLEAN REMIND NOTICE