Sanyo PJLINK PDG-DXL100 - Manual (Page 29)

28
English
User Controls
Eco Standby Power (<1W)
This function is available when the projector is turned off and in
Stand-by. It is recommended to use Eco under normal condition.
 On: lower power consumption than Normal mode in Stand-by
condition.
 Off: normal power consumption in Stand-by condition.
Remote Control
This projector provides two different remote control codes: the
factory-set initial code (Code 1) and the secondary code (Code 2).
This switching function prevents remote control interference when
operating several projectors or video equipment at the same time.
When operating the projector in “Code 2”, both the projector and
the remote control must be switched to “Code 2”.
■ To change the code for the projector:
Select either “Code 1” or “Code 2” in this Setting Menu.
■ To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons together
for 10 seconds or more. After changing the code, make sure the
remote control operates properly.
Closed Caption
This function is a printed version of the program sound or other
information displayed on the screen. If the input signal contains
closed captions, you can turn on the feature and switch the channels.
Use the or to select Off, CC1, CC2.
Power Management
Set the interval of power-off of the system, if there is no signal input.
(minutes/unit)
Sound
 Mute:
■ Choose “On” to mute the volume.
■ Choose “Off” to restore the volume.
 After keystone
adjustment, maybe
need to re-adjust screen
again during display
the closed caption.
Note
 Please turn this func-
tion “Off ”, if you want
to turn on “Power”
by network during
standby mode.
Note