Sanyo PJLINK PDG-DXL100 - Manual (Page 57)

56
English
Appendices
Operation
1. Connect a RS-232C serial cross cable to SERVICE PORT on the
projector and serial port on the PC.
2. Launch a communication software provided with PC and setup the
communication condition as follows:
3. Type the command for controlling the projector and then enter the
“Enter” key.
Example
When you want to change the input to Computer 2, Type ‘C’ ‘0’ ‘6’
‘Enter’.
Serial Control Interface
This projector provides a function to control and monitor the
projector’s operations by using the RS-232C serial port.
Baud rate : 9600 / 19200 bps
Parity check: : none
Stop bit : 1
Flow control : none
Data bit : 8
• The default of the baud rate is set to 9600 bps. If an error occurs in the com-
munication, change the serial port and the communication speed (baud
rate).
• Enter with ASCII 64-byte capital characters and one-byte characters.
Note