Sanyo PJLINK PDG-DXL100 - Manual (Page 30)

English
29
English
User Controls
 Volume:
■ Press the to decrease the volume.
■ Press the to increase the volume.
Lamp Counter Reset
Reset the lamp life hour after replacing a new lamp.
Security Settings
 Security Settings:
■ On: Choose “On” to enable security verification when turning on
the projector.
■ Off: Choose “Off” to be able to switch on the projector without
password verification.
 Change Password:
■ First Time:
1. Press “ENTER” to set the password.
2. Use number buttons to enter default password and then press
“ENTER” to confirm.
3. Use number buttons on the remote to enter your new pass-
word and then press “ENTER” to confirm. (The password has
to be 4 digits.)
4. Enter new password again and press “ENTER” to confirm.
■ Change Password:
1. Press “ENTER” to input old password.
2. Use number buttons to enter current password and then press
“ENTER” to confirm.
3. Enter new password (4 digits in length) using the number but-
tons on the remote, then press “ENTER” to confirm.
4. Enter new password again and press “ENTER” to confirm.
Factory Default
Return the adjustments and settings to the factory default values.
(except for lamp counter, security setting and language)
 Password default
value is “1234” (first
time).
 If you input incorrect
password 3 times, the
projector will automati-
cally shut itself down
and enter into standby
mode.
Note