Sanyo PJLINK PDG-DXL100 - Manual (Page 47)

46
English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
When you see this message, change the lamp as soon as pos-
sible. Make sure the projector has been cooled down for at
least 60 minutes before changing the lamp.
Warning: To avoid
burns, allow the
projector to cool for
at least 60 minutes
before you replace the
lamp!
Warning: To reduce the
risk of personal injury,
do not drop the lamp
module or touch the
lamp bulb. The bulb
may shatter and cause
injury if it is dropped.
Warning: For contin-
ued safety replace with
a lamp of the same
type.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the “ON/
STAND-BY”.
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cable.
4. Use a screwdriver to remove the 2 screws from the cover. 
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module  and pull up
the lamp bar. 
7. Pull out the lamp module by force. 
8. Install the new lamp module by reversing the previous steps.
9. After replacing the lamp, turn on the power, and select the
menu ->[Setting] ->[Lamp Counter Reset] to reset the lamp
usage hours. See page 29.
1
2
4
3