Sharp AR-M700N User Manual
FINISHER AND SADDLE STITCH FINISHER
■ Removing a staple jam in the saddle stitch finisher
Perform steps 1 to 3 of the procedure for
"Replacing the cartridge in the saddle
stitch finisher" on page 3-8.
Remove the empty staple case.
While pushing down on lever
, pull up
Remove any jammed staples, and then
to its original position.
Be sure to remove any
strips of staples.
Return the staple case to its original
Return the saddle stitch holder and the
saddle stitch unit to their respective
Make sure that the finisher is firmly
attached to the machine and that 11" x 17",
8-1/2" x 11"R, or 8-1/2" x 14" (A3, A4R, or
B4) size paper is loaded.
If one of the above paper sizes is not set, test
stapling cannot be performed.
Close the lower cover of the finisher.
Test stapling is automatically performed on a
This operation is carried out to avoid blank
■ Disposal of hole punch scrap (when the punch module is installed)
Open the cover of the hole punch module.
Holding the black handle, slide out the
case containing the paper bits, and
dispose of them properly.
Return the waste case to its original
Close the cover of the hole punch module.
Do not touch the stapling area.
The stapler could injure you.
If test stapling fails to take place, repeat steps 1 to 7.