Spirit Communications System ConnecT/R - Manual (Page 13)

Use the following table to choose the setting
appropriate for your needs.
ADMIN
Setting
Restrictions
1 None. (Allows unrestricted calling.)
2 Prohibits dialing 0 or 1 as the first
digit.
3 Prohibits dialing 0 or 1 as the first or
second digit.
4 Prohibits dialing outside calls.
(Allows making intercom calls
only.)
Step 3 — Mount the ConnecT/R (optional).
The ConnecT/R is designed to be placed on
your desk or mounted on any vertical surface.
Do not place it on the floor. Hardware has been
included to mount the ConnecT/R on the wall:
two plastic wall-mount tabs, two anchors, and
two #6 screws.
1. Select an appropriate location. The
ConnecT/R can be no more than six feet
2.
3.
4.
from its power supply (an AC outlet that
isn't controlled by a wall switch) and no
more than six feet from the devices attached
to it. The bottom of the ConnecT/R should
be at least two feet from the floor.
Position the ConnecT/R so the side with the
jacks and settings is down or to the side, but
not up.
Remove the backing from the plastic tabs.
Gently position a tab by aligning the end of
the adhesive with the outside edge of the
ConnecT/R and the side of the tab against
the inside of one of the feet. Repeat for the
second tab.
Adhesive Area
Plastic Tabs
Feet
Power Cord
down
Power Cord
to the side
9