Spirit Communications System ConnecT/R - Manual (Page 17)

Step 5 — Test the equipment. –
– After the ConnecT/R is installed, test the tel-
phone device and SPIRIT Telephone as follows.
1. To test for dial tone, pick up the receiver (or
its equivalent) of the telephone device and
listen. If there is no dial tone
Check whether the attached SPIRIT
Telephone (if there is one) is in use and
whether the MODE setting is 2 or 4. –
–
–
Check the wiring and power connections.
Be sure that the port on the controller is
administered for Automatic Line Selec-
tion.
2. To test for ringing, call the intercom number
from another telephone. If the telephone
device doesn't ring:
Check that the ringer is turned on and
that its volume is turned up.
Make sure the attached SPIRIT Tele-
phone (if there is one) is not in use.
13
Check the wiring and power connections.
Be sure the port on the controller is
administered to ring for lines that are
available.
You can check the SPIRIT Telephone in the
same way.
If you have any problems, see the Troubleshoot-
ing section of this manual for more information.
–
–