Security Systems 808 - Manual (Page 12)

12 of 22 496336 Issue 1
Changing Menu Items
After selecting a menu, press Enter to see further options belonging to that
menu. The system usually displays an abbreviation for the name of the
option, and the values the option currently has. A flashing character marks
the part of the display that will change when you next press a key.
During programming you can select options within the menu and change their
value by using the arrow keys:
Note: On the 927 keypad the A, B, C and D keys behave as arrow keys. The sticky
label provided with the keypad shows how they function during programming.
Make sure you place this label in the space next to the keys under the flap of
the 927.
• The up and down arrow keys (A and B) normally let you select which
part of the system an option will affect. For example, menus 31 and 32
use the up and down arrow keys to select particular zones or areas.
Once you have selected a zone press Enter to start the zone type
flashing. Use the up and down arrow keys to select the zone type.
Menus 40 to 47 use the up and down arrow keys to select Areas or
Levels.
• The left and right arrow keys (C and D) either show more options
belonging to a menu or let you move the cursor to individual param-
eters that you wish to change. For example, once you have selected a
zone type in Menu 32, use the right arrow key to select a zone at-
tribute.
• For some parameters, the up and down arrow keys also let you toggle
between on or off, Y (yes) or N (no), or a short list of allowed values.
For example, menu 32 uses the up and down arrow keys to switch
zone attribute on or off.
When you have finished changing an option press Enter to store the change.
Correcting mistakes
If you decide you have made a mistake then you can abandon a change by
pressing Menu instead of Enter. You can then re-enter the menu to key in the
correct value. You can use the Menu key to escape from any part of the
program.
Zone Programming
As an example of programming the system, this subsection shows you how
to program an individual zone's type, area and attributes.
1. Enter programming mode if you have not already done so.
2. Select Menu 32 and press Enter.
Changing Menu Items 808