Security Systems 808 - Manual (Page 16)

16 of 22 496336 Issue 1
2. Press Menu.
If the end station lid is open, the displays shows: REPLACE LID
3. Close the end station lid.
If no faults are present the display shows the
time:
09:00
If faults exist, the display will show, for example: CANT EXT
01 FLTS
REVIEW FAULTS
4. Use the up and down arrow keys to view faults present on the system.
Remedy the faults, then press Menu until the display returns to the time
and date.
If the display shows a "CFG ERR" (configuration error),
for example:
CFG ERR A IN LA
Then see "Fault Finding" for an explanation of the fault and how to
correct it.
Re-entering Programming Mode
To enter Installer Programming Mode:
The display shows the time: 12:15
1. Key-in 0 (zero) followed by the Installer code (default 7890), then press
Menu.
The display shows: MENU NO OR LEVEL
2. Press 0.
The display shows: 0:INST PROG
3. Press Enter.
The display shows REMOVE LID
4. Remove the end station lid.
The display shows: 00:PROG SYSTEM
You have now reached the Installer programming mode.
Engineer Reset
If you wish to perform an Engineer Reset without removing the end station
lid, type-in 0 (zero) + Engineer Code, (default 7890) then press Enter.
Re-entering Programming Mode 808