Security Systems 808 - Manual (Page 13)

496336 Issue 1 13 of 22
The display shows the zone number and current attribute.
Note that the zone number is flashing (shown here by an
underline).
Z01-NU
To select a zone number:
3.
Press the up or down arrow keys (A or B) until you see the zone number
you want (in this example zone 3).
The display shows: ZO3-NU
4. Press Enter.
The displays stops flashing the zone number and starts
flashing the zone type:
ZO3-NU
To select the zone type:
5.
Press the up or down arrow keys (A or B) until the display shows the
two letter code for the zone type you want (in this example NA for
Normal Alarm).
The display shows: ZO3-NA
To allocate the zone to an area:
6.
Press the right arrow key (C).
The display shows the current area number: Z02-NAA1
7. Press one of the number keys 1 to 4 to select the area
you want the zone to belong to (in this example Area 3).
The display shows the Area number you selected: ZO2-NAA3
To allocate zone attributes:
8.
Press the right arrow key (C).
The display shows a letter code for the first of the
available attributes belonging to the zone type you
selected earlier. (In this example the zone type was
NA and the first available attribute is C (Chime).) The
letter to the right of the attribute code shows whether
the attribute is enabled (Y) or disabled (N).
Z02-NACN
9. Press the up or down arrow keys (A or B) to enable or disable the
attribute (in this example Chime is enabled.)
The display shows: Z02-NACY
10. Press the right arrow key to select the next available attribute.
The display shows the next attribute available for the
selected zone type (in this example O (Omit)).
Z02-NAON
11. Press the up or down arrow keys (A or B) to enable or disable the
attribute.
808 Zone Programming