Kathrein UFD 420 - Manual (Page 12)

Receiver operation
12
“Pseudo-Stereo" can be used to simulate a “stereo-like“ effect with mono pro-
grammes, and should thus only be activated with mono reception.
If Pseudo-Stereo has been turned “On“, the stereo width can no longer be altered.
Muting the sound
The unit is in normal mode (TV or radio mode).
•
Press the key.
The sound is muted, allowing you to make a phone call undisturbed, for example.
In the OSD, Sound off is displayed for approximately 3 seconds. In the LED display
the sound muting is shown by means of 3 dots. After changing programme, the
message Sound off is displayed again.
•
If you press the key again the sound is turned back on.
Note Mute is not operative at the VCR Scart socket.
Stereo- / Mono- / Channel changeover
TV broadcasts can be transmitted in the two-tone channel method
(e.g. original tone “English" on channel 1, “German" tone on channel 2).
•
Press the key. Each time you press the key, you switch the sound channel in
the order,
Sound channel 1
→
Sound channel 2
→
Stereo.
The selected channel is shown on the screen and in the LED display. The setting is
not saved. After a change in programme the original setting takes effect again.
SAT/TV changeover
Where the satellite receiver and TV set are connected via a Scart cable, many
older TV sets immediately switchover signal input (on the Scart socket) to video re-
ception when the satellite receiver is turned on. The switching voltage of the TV
Scart socket therefore needs to be switched off if you want to view a terrestrially
broadcast TV programme..
•
Press the key.
The switching voltage on pin 8 of the TV Scart socket is turned off, and it is turned
on again by pressing once more.
In TV mode, “TV mode“ is displayed on the screen, the programme slot indicator in
the LED display begins with “T...“.
In Sat mode, “Sat mode“ is displayed on the screen, the programme slot indicator
in the LED display begins with “P...“.
Setting date and time
The unit is in normal mode (TV or radio mode)
•
Press the key to call up the menu for date and time setting, and turning the
continuous time display on/off.