Kathrein UFD 420 - Manual (Page 23)

Programming radio programmes
23
Programmieren von Radio-Programmen
Programme providers also broadcast radio programmes via the satellites. The
“Radio“ menu allows you to store new programmes.
The settings for radio programmes in “Radio“ mode are carried out in the same
way as for the “TV“ mode.
Tuning in radio programmes
•
Switch from “TV mode“ into “Radio mode“ using the key.
•
First select the programme slot that is to be programmed anew.
•
Call up the radio menu by pressing the + keys in succession.
•
Select the desired menu line using keys the keys.
•
For direct numeric input use the keys ...
or
•
Alter the values step-by-step with the keys.
•
Press the key twice in order to save your settings.
•
Exit from the menu with the key.
Note Pay attention to the note on memory organisation of TV and radio programmes on
page 18.
The "Radio" menu
The following parameters can be selected in the radio menu:
Setting option:
Programme slot: from 1 to 250
Programme name: 5-character station identifier
Sat-transm. freq.: from 10700 to 12747 MHz
Polarisation: Hor Low / Vert Low /
Hor High / Vert High
Orbit Position: 1 to 4
Oscillator: LO 1 to LO 4
Modus: Mono wide, Mono narrow, Stereo
Sound carrier freq.: from 5.00 to 8.98 MHz
Audio de-emphasis: 50
µ
s / J 17 / dnr,75
µ
s
Volume offset: from 0 to –3
The bottom line shows the keys you can use to make the settings.
Radio programmes are transmitted on sound subcarriers only. The setting to be
made is therefore either “Stereo“ or “Mono narrow“. Here the audio de-emphasis is
selected automatically as “DNR“ and 75
µ
s.
Settings are carried out in the same way as for the TV programmes.
The initial setting for the volume can be saved separately for every programme slot
just as in the TV mode.
Setting option with keys from 0 to –3.
Note You can terminate any setup procedure immediately (also without storing) by re-
turning to normal operation via the
key