Kathrein UFD 420 - Manual (Page 24)

Initial settings
24
Grundeinstellungen
In the initial setup menu, matching of the satellite receiver to the satellite receiving
system is carried out.
Important The receiver has already been factory pre-programmed for standard satellite re-
ceiving systems.
Alterations to the initial setting are therefore necessary only if your receiving sys-
tem deviates from this type of installation or if you happen to want different set-
tings.
The settings in the initial setup menu are generally carried out by the specialist
dealer on installation of the satellite receiving system.
To prevent any unintentional alterations in the initial settings, the initial setup menu
can be invoked only from the switched-off state.
Calling the initial setup menu
•
Switch the unit into standby.
•
Press both the programme selection buttons (4) on the receiver si-
multaneously and keep pressed.
•
Switch the unit on via the key on the remote control.
•
Release the buttons when “C 38“ appears on the LED display.
C 38 is the factory preset UHF output channel. If the UHF channel has already
been altered, the appropriate channel selection appears
(between Ch. 21 and Ch. 69).
The initial setup menu is displayed.
Setting option:
Modulator: Channel 21 to 69; assign to TV or VCR
OSD language: German / English / French
LNB supply voltage: ON / OFF
in standby: OFF / ON
Programme selection: 1-, 2-, 3-digit, free entry
OSD: On / Off (can be set individually for TV and radio)
LED brightness: Low / High
Type of remote control: 24 keys or 26 keys
Oscillator menu: LO 1 to LO 4 (each 9000 ...12000)
DiSEqC menu: See separate menu in section “DiSEqC"
The bottom line shows the keys you can use to make the settings.
Settings are made in the initial setup menu in the same manner as in the other
menus for the station programming:
•
Select menu entries with the keys.
•
Carry out settings and call up submenus with the keys
(and use numeric keys ... on inputting frequency).
•
Press the key twice to save your settings.
•
Return with the key.
Modulator output channel
The modulator‘s UHF output channel can be entered in the range from channel 21
to 69.
Default: channel “38“