Kathrein UFD 420 - Manual (Page 19)

Programming TV programmes
19
•
Select the desired menu line using the keys .
•
For direct numeric input use the keys ...
or
•
Alter the values step-by-step using the keys.
•
Press the key twice in order to save your settings.
•
Exit from the menu using the key.
The settings are applicable for the TV- and VCR branch.
Note Frequent reference is made to saving the settings in subsequent descriptions. It is
always sufficient, however, if you save the settings in the video and audio menus
just once before exiting from the programme slot or before exiting from setup
mode.
The "Video" menu
The following settings can be made in the video menu:
Setting option:
Programme slot: 1 to 250
Programme name: 5-character station identifier
Sat-transm. freq.: from 10700...12747 MHz
Polarisation: Hor Low / Vert Low /
Hor High / Vert High
Orbit position: 1 to 4
Video deviation: 16 or 25 MHz
Oscillator groups: LO 1 to LO 4
Decoder menu: See separate decoder menu
The bottom line shows the keys you can use to make the settings.
Description of menu entries
Satellite frequency
With input via the numeric keys ... frequency input is in 5-figure form in the
range 10700 to 12747 MHz. With the keys you can attain the optimum receiv-
ing frequency by moving in 1 MHz steps (recommended if the picture is grainy due
to weak signals).
Polarisation/Oscillator
In menu entry “Polarisation“, the voltage level is used (14 or 18V) to set the polarity
(vertical or horizontal).
In the “Oscillator" menu entry, the oscillator frequency group LO 1 to LO4 is se-
lected. With the oscillator frequency the high satellite frequency is converted to the
satellite IF frequency. This allows troublefree matching to different feed systems.
Frequency range Polarisation LNB-
voltage Setting LO-
group LO-
frequency
10.70 – 11.70 GHz
10.70 – 11.70 GHz horizontal
vertical 18 V
14 V Hor. Low
Vert Low LO 1
LO 2 9750 MHz
9750 MHz
11.70 – 12.75 GHz
11.70 – 12.75 GHz horizontal
vertical 18 V
14 V Hor. High
Vert High LO 3
LO 4 10600 MHz
10600 MHz
For setting of LO frequencies refer to section: “Initial setting".