Kenmore 625.348670 - Manual (Page 6)

SIGNAL
LIGHT
ADJUST
DOWN button
UP button
display
#1 SELECT
button
ON/OFF--HOLD button
(Recharge Tonight--Now)
SELECT
1
ON/OFF
HOLD
RECHARGE TO-
NIGHT RECHARGE NOW
Genius II Water Softener
Kenmore Water Line
for Customer Assis-
tance
1--800--426--9345
SALT
LEVEL
ADJUST
LOW SALT
salt level
adjust button
signal light
adjust button
TANK
LIGHT
SELECT
2
#2 SELECT
button
tank light
on/off button
low salt
indicator
WATER SOFTENER START-UP
SECTION 1
6
1C. PROGRAM THE TIMER
FIG. 1
When the transformer is plugged in, the model code
HF32, and a test number (example: A2.0) show in the
faceplate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
AM
PRESENT TIME
8
7
6
5
4
3
2
1
SALT
LEVEL
SIGNAL
LEVEL
8
7
6
5
4
3
2
1
SALT
LEVEL
SIGNAL
LEVEL
NOTE:
If HF-- shows in the display, press the UP or
DOWN button until HF32 shows. Then, press
the #1 SELECT button to set, and change to the
flashing PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again. If other than HF32
shows, see page 19 to reset.
SOUND “BEEPER”: A “beeper” sounds while
pressing buttons for timer set-up. One beep signals a
change in the faceplate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness (step
2), the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest
hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words¼ PRESENT TIME do not show in
the display, press the #1 SELECT button (FIG. 1)
until they do, or see the notes above.
n Press the UP/DOWN buttons to set the
present time. Press UP to move the display ahead;
press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP/DOWN
buttons changes the time by 1
minute. Holding the buttons in
changes the time 32 minutes each
second.
2. SET WATER HARDNESS NUMBER:
n Press the #1 SELECT button once to display 25
(flashing) and HARDNESS.
The grains per gallon (gpg)
hardness of your water supply is
on your water analysis report. Be
sure to enter water test results on
page 2, for future reference.
PM
PRESENT TIME
8
7
6
5
4
3
2
1
SALT
LEVEL
SIGNAL
LEVEL
AM
PRESENT TIME
8
7
6
5
4
3
2
1
SALT
LEVEL
SIGNAL
LEVEL
HARDNESS
8
7
6
5
4
3
2
1
SALT
LEVEL
SIGNAL
LEVEL