Kathrein UFD 545 - Manual (Page 17)

OSD On-Screen Displays
17
Bildschirmeinblendungen / OSD On Screen Display
Important on-screen displays
The receiver functions are controlled by a microprocessor and extensive software.
The following explanations are intended to improve understanding of all
procedures and to minimise the risk of mistakes.
TV channel identifier
The channel identifier is displayed for
several seconds every time the channel is
changed or by pressing the
O
button.
The
I
indicates that a channel is received even if no picture can be seen (e.g.
radio). The film symbol indicates a TV channel with the selected channel shown
next to it and whether video text is received. The current time, start time and end
time of the current programme are shown on the next line provided these data are
transmitted. The
+ in the third line stands for the channel selection from the main
channel list. If the favourite list is selected, you will see the "apple" symbol at this
point. This is followed by the set sound reproduction mode (depending on the
direction of the symbolized sound waves, mono left, mono right or stereo can be
set, the digit indicates the number of sound channels). The channel title is shown in
the box on the right.
Radio channel identifier
The identifier for the set radio channel has
the same configuration. A music note at
the top left indicates that this is a radio
channel. Programme times and text are displayed only if the corresponding data
are transmitted with the signal.
Error message
"Bad or no signal" indicates that there is a
fault in the reception system or in the
receiver settings or the transponder is not
transmitting. Instead of the
I
, the channel
identifier shows a satellite antenna together with the message "bad or no signal".
Check the SAT-IF connection and the LNB configuration. As an aid, refer to the list
of service settings provided at the end of this User's Guide.
TV channel list
Press the
i
button to show the channel
list. A + for the main channel list or the
"apple" symbol is indicated at the top left.
The list can be changed by pressing the
button again. Information relating to the
received satellites, the polarization, the
symbol rate, scrambling, favorite or
standard channel and the parental control
is provided in the column below the
symbol. The column on the left contains
information relating to the channel, the
channel provider and whether the channel is normally scrambled. The required
channel can be selected with the bar cursor and confirmed by pressing the
O
button.
Radio channel list
See above. The same applies to the radio channel list.