Kathrein UFD 545 - Manual (Page 27)

Adding/Removing Satellites
27
gen/entfernen
To set up satellites
New satellites, can, of course, be included in the LNB configuration.
Due to the associated on-screen displays, all settings and editing must be made
from a digital channel slot.
For this purpose, you must know the orbital position of the satellites in order to
align the antenna (satellite dish). The menu point "antenna settings" in the
installation menu can be used as an aid for the purpose of aligning the antenna.
After accessing the main menu
M
and
the submenu "Installation" – press the
ou
and
O
buttons (plus
password) to select "LNB configuration".
Select this setting with
O
, you can now
enter or select a new satellite.
Bear in mind that your system must be set
up accordingly!
In the next step, press
o
u
to go to, e.g. the entry "User1".
After pressing the
-
or
+
buttons, the on-
screen display shown opposite appears.
Confirm by pressing
O.
You now see the message:
You can now make the entries corresponding to your receiving system at the
necessary positions with the buttons
o
,
u
and
-
or
+
and then exit the
menu by pressing
L
3 times. The new satellite data are saved simultaneously.
Use the number buttons on the remote control to make the alphanumeric entries.
Refer to section "Notes on operation" for information on the exact procedure.
Changes being saved
Please wait