Kathrein UFD 545 - Manual (Page 42)

Installation Menu
42
Tone burst
Under this menu point, the 22 kHz signal can be set as follows:
Switching statuses of setting: Switching statuses of setting: Switching statuses of setting:
22 kHz Signal —> High/Low
and
Tone Burst —> Pos. A/B:
22 kHz Signal —> Pos. A/B
and
Tone Burst —> Opt. A/B
22 kHz Signal —> Pos. A/B
and
Tone Burst —> High/Low
Low
High
22 kHz
22 kHz OFF
ON
Pos Tone Burst 22 kHz Low
High
Tone Burst
Tone Burst 0
1
Pos. 1
Pos. 2 Tone Burst
Tone Burst 0
1
1
2
3
4 0
0
1
1 OFF
ON
OFF
ON
Pos. 1
Pos. 2 22 kHz
22 kHz OFF
ON
DiSEqC
If the receiver is connected to a DiSEqC switchover matrix, you will need to set this
menu point to ON.
The switching criteria and the input assignments of the DiSEqC switching matrix
must be maintained. Therefore, refer to the description of the switching matrices or
contact the installer of the receiving system.
DiSEqC repeat
The DiSEqC command must be repeated if the receiver is operated (cascaded)
together with a receiving system with two or more series connected DiSEqC
switching matrices.
In this case, switch the menu point "DiSEqC repeat" to 1 or 2.
Factory presetting: OFF
UFO mini
The input frequency of the receiver is fixed in a "user-controlled processing
system". The signals from the "user-controlled processing system" are transmitted
on this frequency. The reception parameters for channel selection are transferred
to the receiving system by means of a DiSEqC command and set accordingly.
The relevant setting that needs to be selected depends on the type of "user-
controlled processing system".
The setting should be made according to the data provided in the installation
instructions for the "user-controlled processing system".
Remote frequency
If you have set the UFO mini menu point to "ON" or "OFF", you will need to set the
transmission frequency under this menu point.
Refer to the installation instructions of the "user-controlled processing system" for
the set transmission frequency.
It is therefore important that you refer to the information provided in the installation
instructions of the "user-controlled processing system".
UFO micro
The setting under this menu point is also designed for operation of the receiver
together with a processing system.
Control and communication between the receiver and the Kathrein UFO micro
system takes place on the return of the coaxial cable.
ON must be set under the UFO micro menu point if the receiver is operated
together with a UFO micro receiving system.
During installation, the receiving system then assigns a special address to the
receiver so that the control instructions that are sent from the receiver to the
receiving system for signal selection are also recognized by this system.
A remote frequency need not be set in this operating mode as it is defined by the