Kathrein UFD 545 - Manual (Page 18)

Channel selection
18
Programmemwahl
This section describes how you select analogue and digital TV channels with your
receiver and how you can set the required volume.
This description of the functions assumes that the receiver has been connected
correctly.
If you wish to connect the receiver yourself, please read the section "Connection
and start-up" beforehand.
Selecting a TV channel
Reception status – digital
The following information describes how to select digital reception of other
channels and shows what the on-screen displays look like.
After switching on the receiver, simply press the
ou
buttons in order to
select other TV channels in their ascending or descending order in the channel
memory.
Every time you press the button, an on-screen display shows you the selected
channel together with the time, the programme start and end times as well as the
channel title in the information box provided these data are transmitted together
with the signal.
By pressing the
O
button, you can leave
this information box permanently
displayed or switch it off by pressing
the
button once again.
You will receive the "channel scrambled"
message for scrambled channels.
A further option of selecting a different channel is to press the
i
button. The TV
channel list is now displayed. In the left column it will provide information relating to
the received satellites, the transponder and its transmission frequency, the
polarization, the symbol rate and the scrambling of digital channels. The right side
shows the channel number, the channel broadcaster and the type of reception
signal (analogue/digital).
By pressing the
ou
buttons you jump to the next channel and by pressing
the
-+
buttons you jump to the neighbouring page.
Confirm your selection by pressing the
O
button.
Press the
L
button to exit the channel
list and remain in the channel already set.
If you have now selected an analogue
channel, as confirmation, the plain white
display for this type of transmission will
appear (see below).