Klegg electronic M6 501P - Manual (Page 17)

16
M6 501P Operation – Test Mode
Test Mode
power
balance delay prologic
field EQ on/off EQ setup
preset 1 preset 2 preset 3
mute
After completing the installation, press the TEST Button
on the remote to see if the system functions properly.
You can also use the test mode to test the location of
the speakers. When the TEST Button is pressed, white
noise is emitted through all the satellite speakers in the
order of L, C, R, SL, and SR channels for 2 seconds
each. When completed the M6 501P returns to Auto
Decode mode.
When Test Mode is activated the M6 501P will display the following information in the
following sequence:
D o l b y D i g i t a I C o
T E S T L
D o l b y D i g i t a I C o
T E S T C
D o l b y D i g i t a I C o
T E S T R
D o l b y D i g i t a I C o
T E S T S L
D o l b y D i g i t a I C o
T E S T S R