Klegg electronic M6 501P - Manual (Page 21)

20
M6 501P Operation – Time Delay Adjustment of Center Channel Speaker
Delay Calibration
DRC
balance delay prologic
field EQ on/off EQ setup
preset 1 preset 2 preset 3
save preset 4 load
Cen
SW
VOL
SL/SR
D Time
Press the DELAY Button to select the length of
delay time for SL/SR/C channels. Repeatedly
pressing the DELAY Button will allow you to
choose from the 3 surround speakers (SL, SR, C.)
The delay time range for SL/SR is 0 to 15 ms and
0 to 5 ms for Center.
Adjust the delay time on the selected channel by
pressing D TIME + or D TIME - on the remote
control.
Press the DELAY Button and the M6 501P will display the current delay time for channel LS.
D o l b y D i g i t a I C o
D E L A Y S L 5 m s
Press the DELAY Button again and the M6 501P will cycle to next channel.
D o l b y D i g i t a I C o
D E L A Y S R 5 m s
Press the D TIME + or D TIME - button and the M6 501P will increase or decrease the delay
time for the current channel.
D o l b y D i g i t a I C o
D E L A Y S R 6 m s