Klegg electronic M6 501P - Manual (Page 29)

28
M6 501P Operation – Equalization
5–Band Equalization
DRC
balance delay prologic
field EQ on/off EQ setup
preset 1 preset 2 preset 3
save preset 4 load
Cen
SW
VOL
mute
SL/SR
D Time
The M6 501P features an on board 5-band equalizer
which allows you to fine-tune the sound of your favorite
movie/music. Press the EQ SETUP Button on the
remote to activate. Repeatedly pressing the EQ SETUP
Button will cycle through the 5 bands.
Each band of the equalizer allows a 10dB range of
volume adjustment. By pressing VOL + or VOL - on
the remote control you can achieve your desired
volume.
After setting up the desired volume for each EQ bank
you
must press EQ SETUP Button again to enable the new
EQ setting.
Press the EQ ON/OFF Button to execute the new EQ
setting.
Pressing the EQ SETUP Button will display the current setting of EQ Band 1.
D o l b y D i g i t a I C o
E Q B A N D 1 0 d B
Pressing the EQ SETUP Button again will cycle to the next EQ Band.
D o l b y D i g i t a I C o
E Q B A N D 2 0 d B
Pressing the Vol+ or Vol- will increase or decrease the volume for the current EQ Band.
D o l b y D i g i t a I C o
E Q B A N D 2 + 0 1 d B
Press the EQ SETUP Button to enable the new EQ setting.
Press the EQ ON/OFF Button to execute the new EQ setting.